This article is to document the CLI commands used to configure an Autonomous Cisco Access Point.
To configure the AP management IP address use the following command:
Interface BVI1
ip address [ip] [subnetmask]
no shutdown
Next, define the SSID properties including Name, Key method and password.
This particular configuration is using WPA2 to authenticate the users.
dot11 ssid [SSIDName]
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii [password]
Next you will push this SSID on the 2.4 Ghz which is on interface dot1Radio 0 and if you want it to be available on 5 Ghz band as well, you will configure it on dot1Radio 1. The radio will be using the AES-CCM encryption mode.
interface dot1radio0
encryption mode ciphers aes-ccm
ssid [SSID-name]
no shutdown
Once you are done, you can save the configuration and test you wireless device.
IT Wiz Technology Blog 